VPI Classic 2 Turntable Setup and Instruction Manual VPI Industries, Inc., 77 Cliffwood Ave. #3B, Cliffwood, NJ 07721 phone: 732-583-6895
9 Set the arm height as follows: Start the turntable and place a record on it. Lower the arm onto the record and make the arm tube parallel to th
10 Place the rubber washer on the platter spindle, then the record on the platter, then screw the clamp onto the spindle. The clamp
1 Important: Read Before Proceeding! Read and follow the Safety Instructions below. Save all packing materials. The Classic 2 should only be mo
2 Unpacking the Box The turntable and tonearm are packed very carefully to avoid damage during shipping. It is important that you save the packing ma
3 The platter bearing is lubricated; no additional lubrication is needed for at least one year. Remove the platter from the smaller
4 A. CARTRIDGE MOUNTING: FOR CARTRIDGES WITH THREADED MOUNTING HOLES: Use the screws supplied by the cartridge manufacturer to mount the
5 Place the arm tube assembly on the lower bearing, taking care not to strain or damage the 4-color wire and Lemo connector. Place the arm in its
6 Place the arm back in its rest. Without letting the cartridge move, tighten the screws holding the cartridge to the arm head. Make it tight,
7 The Classic 2 arm does not have a built-in tracking force gauge, but a Shure Stylus Force Gauge is supplied with your arm. F
8 E. ANTI-SKATING: REMEMBER: A 10.5” ARM NEEDS VERY LITTLE ANTI-SKATING FORCE Anti-skating is one of the least understood forces acting on a t
Kommentare zu diesen Handbüchern